What I do
I design circuit boards — mostly RF and dense digital — and write the firmware that runs on them.
Phased array front ends, control boards talking to an FPGA, VHDL for the logic in between, STM32 firmware where a microcontroller fits. Enclosures too, when a project needs one.
Skills
PCB & Layout
- Altium Designer
- 2–6 layer stack-ups
- Controlled impedance
- DFM review
Digital & FPGA
- VHDL
- Vivado
- Custom IP cores
- SSI / encoder interfaces
Firmware
- STM32 HAL
- Bare-metal & RTOS
- Embedded Linux (Buildroot)
- DMA / SPI / UART
RF & Antennas
- Phased arrays
- Beamforming
- TX / RX front ends
- Pattern simulation
Mechanical
- SolidWorks
- Enclosure design
- Motor design
- Machine build
Experience
2023 — Present
Hardware Design Engineer
PROFEN
- Antenna control board design driven by FPGA
- Antenna motor control board
- FPGA systems and VHDL development
- Phased array antenna RX/TX PCB design
2023
Intern
PROFEN
2022 — 2023
Long-term Intern
YASA Technology
- Manual pick and place machine
- DC motor driver
- Heater control circuit
- Power logger
2022
Intern
Hidromechanic
- Hydraulic cylinder design
Education
Mechatronics Engineering
Bursa Technical University
2017 — 2023
Mecidiyeköy Anatolian High School
Istanbul
2013 — 2017